| Thread | Last Post | Replies |
|
| Motorola T072C from 1988 | 13 Jun 2007 12:38 GMT | 2 |
yes T , not TL, could be To72C i suppose, dual opamps Does anyone know the maximum supply rail voltages. ? I will replace with TL072 as ps fault allowed the secondary supplies to these to go well beyond +/- 15V at some point, just wondered if they were
|
| KSS-213B pickup changed | 13 Jun 2007 02:58 GMT | 1 |
I changed a KSS-213B pickup in an aiwa CD player. the old one would pickup CDs sometimes, but most of the time it wouldnt, and the CDs it did pick up it would only play a track real noisy before loosing out. So I changed the pickup, but the new one dont work at all. i read ...
|
| RCA Plazma TV. | 12 Jun 2007 19:08 GMT | 2 |
RCA Plazma, under warranty, Model # P42WED33, unit has vertical bars running down the right hand side of the screen, about 1/3 of the screen has lines that can be seen only on dark
|
| Seeking Dual Car Battery Installation Advice | 12 Jun 2007 17:30 GMT | 13 |
I'm about to configure my 97 Plymouth van so that it has two batteries. The second battery will be kept in the rear of the van in a battery box with a vent through the floor. I'm using a Mega-Tron RV-Marine Deep Cycle 12v battery, which will provide power to a medical device at ...
|
| Power Transformer Replacment | 12 Jun 2007 14:20 GMT | 19 |
I am in the process of replacing a power transformer in a musical instrument amplifier (solid state). As the existing transformer doesn't currently pass the continuity test across the primary, and the coil wire seems to be broken somewhere in the coil, I am thinking of
|
| Awkward power tranny to heatsink spring clip | 12 Jun 2007 14:19 GMT | 5 |
Anyone know the correct way to remove and replace or even initially place (without possibly straining the legs of the tranny by lateral forces) such spring clips as in this 2 angle view ,combined pic, I took http://home.graffiti.net/diverse:graffiti.net/clip.jpg
|
| Laptop LCD repair. INVERTER or BL ? | 12 Jun 2007 12:33 GMT | 4 |
Having a laptop with a suspected bad backlight or Inverter. I had changed the BL but still no display. Can see the image on the screen with a flashlight but the BL doesn't lit. How can I confirm if the Inverter is OK ?
|
| PC Board | 12 Jun 2007 03:05 GMT | 5 |
I would like to make a PC board of a small circuit... is there any programs that can help me accomplis this?
|
| Tuning Mitsubishi CT-2153STX | 12 Jun 2007 01:37 GMT | 1 |
We have a Mitsubishi CT-2153STX that was working fine, until our friend's child pushed a button on the front(maybe?). Now it just has white noise (fuzz) and says "28:........ AFT ON UHF )))))))))))))))))......................"
|
| Diode search | 11 Jun 2007 19:13 GMT | 4 |
I am trying to locate or cross reference two diodes. Both are located between the horiz. and PCC circuit in this Sanyo model #HT32744. Both are shorted. Part # on diodes (FMPG3F, FMCG28). I searched this site and found one post for FMPG3F where the guy was looking for a
|
| Can a battery charger/conditioner be used on smaller batteries | 11 Jun 2007 17:56 GMT | 2 |
I acquired a marine battery charger/conditioner (Promativ 40-3). I just tried it on the battery from a lawnmower which at first showed less than 7 volts (12V battery). My car battery 10 amp charger could barely get any current into the battery (barely moved the meter).
|
| Vibration failure of components in bass combos | 11 Jun 2007 13:46 GMT | 4 |
Yet another one, an unsupported 3W resistor , with a fractured wire. Doesn't matter what maker, none of them seem to take this failure mode into consideration. The common factors bass combo (so far only bass ones ), large Rs suspended off the board, can be mounted vertically or ...
|
| GM car radio | 11 Jun 2007 05:16 GMT | 2 |
For those who don't know, I like old things. I have an 89 Park Avenue, and the right channel is out on the stereo. Surprisingly the cassette works prefectly. Scrapped a 90 Olds Delta 88 not too long ago, and today I had my guy
|
| rebuilding a computer keyboard | 10 Jun 2007 23:40 GMT | 17 |
I have a keyboard which I love, and which is beginning to wear out. (It's a DataDesk SmartBoard.) I am trying to get a hold of a replacement, but the company has been apparently imploding for years -- none of the linked distributors have it (except perhaps a company in Canada), the ...
|
| Dental burrs revisited - for UK readers | 10 Jun 2007 20:14 GMT | 4 |
Mr Cook was asking about dental burrs a while ago, CPC in Preston have a set of 30 diamond burrs on offer for just £2.74 + vat www.cpc.co.uk Product code TL1035904 Ron(UK)
|