Electronics Forum / Repair / October 2006

Hope this reaches older TV techs from Uk or Europe ;-)
Set in question: ITT model 1922u, with 20 axu chassis.
Am trying to restore this early transistorised colour, ultrasonic
remote set. Estimated vintage 1976 or thereabouts.

I am writing this message after careful checking of times and lighting
of errors/tapes. I have the vcr mentioned in the message subject and I
have the following problems and no idea on how to fix them:
- the top part of the screen is "bent" to the left for an inch or so

Sign board in question is a LaBelle industries express 152 (of around
1989 vintage) that works, but is missing the keyboard and a hunt for a
replacement has been futile.  I found a wired keyboard from the same
manufacturer, but there is no place to plug it into the sign.  The IR

My snd VCR is broken and I'm hoping somebody can help me locate power supply
prints or offer advice on what might be teh cause
The unit does not power ( either through teh button or teh Remote) on but
the display does show blinkingt time 12;00;00.

Hi;
I don't know how many of you sell used TVs, but those of you who don't
might be able to clue me in on what kind of repair estimates are being
authorized for this set.

I need some inputs from people who are very familiar with these
monitors please. I have a 15 inch LCD monitor where the screen goes
dark (blank-nothing) one second after I turn it on. The green power
light on the front as well as sound stay on. What can be causing this,

I have a Mitsubishi VS-4504 CA projection tv that won't turn on .One of
the resistors on the power supply board was burnt , I replaced it but
it still won't work . Any one out there that might be able to help get
me in the right direction to try to fix this ?

I have 3 with the same fault, the printer asks to align cartridges, i press
start, the printer makes a sound
as if it's printing but no paper is loaded.
The motor works as paper is loaded when the machine is turned on.

Model 32UF6 ... 2003 flat screen .
The screen comes on very bright white with retrace lines . I can see no
menues
If i turn up the flyback screen control the picture squeezes in on

I have a sharp CF30E50 30" crt TV i was working on for a customer that
came in with no Vertical sweep. Soldered it up. Replaced the vertical
output chip. ESR'ed in circuit around the chip and did not find anything
out of the ordinary. Worked fine for a couple of days and then it ...

Myu sons VCR recently failed to tun on either through teh button or the
remote
I just get a blinking 12:00:00 on the screen
The power button is fine and I assume the prob is in teh Power supply

Hi all organ-fans out there. I would like to help a friend with his
BALDWIN ORGA-SONIC 71 organ. It has a fairly low volume. I have no
schematics or service-manual to help me. Is there someone been into a
similar problem with these specific organ.

ok, i'm just guessing it's a shutter problem, but everything else is
working and all i see is BLACK.
i was thinking that chip is broken, but i suppose that everything else
would've stop working... but that all could be wrong of course.

Had battery issues with a new digital camera and put in a new pair of
non-alkaline AA's.  Camera would not power up, just flashed an led green for
a flash on two then red for a couple of flashes.  Took batteries out and put
them in a flashlight and its as bright as can be.  Back ...

every now and then my 5 yr old philips refuses to come out of stand by,
instead screen remains blank and i can hear a sort of pinking  or
clicking sound (like oil in an electric heater) , every second or two.
if i turn unit off and on again it works.