Electronics Forum / Repair / September 2006

Michael Kennedy wrote:

Go

Miller votes in favor of fence across U.S.-Mexico border
RALEIGH, N.C. North Carolina congressman Brad Miller has been
criticized by his Republican opponent on immigration issues.
But yesterday, he voted in favor of an immigration bill that includes a

If anyone has one of these old beasts in the heap that might have a good
motor, please contact me.  I suspect most of them are failing in the same
way from some of the posts that I have found in other forums, but maybe
we'll get lucky...

I have a tuner out of a old zenith Sentry set, it has 175-2402 part
number, this one has four inline pins and 4 smaller pins that look like
power.
Would like to get the pin out information of the tuner.

Hi Group, I'm repairing a 17" LCD and can't seem to obtain a 2SC5707 in
Australia. Does anyone know of an equivalent? Ta Mouse

I have a battery pack of a skiboot heating system broken (from Therm'ic
vendor).
The battery pack consists in a 5.3V battery and a 3 positions switch
enabling graduous heat in the feet. This is done thru an oscillator

I read Sam's stuff on 'slight jitter in TV picture' but I do not have a
grasp on it.  My Mitsubishi 27 from the 80,s has a slight jitter.  I
noticed it when you bring up the display of setting with a blue screen.
Then I was aware of it after that on regular TV.  Cheap to fix or it

Use of external mouse wore out double USB connector on HP5700 laptop
computer. No such parts available from HP (of course).
Anyone know where to find such? It is a PC board mounted affair with the two
USB connectors long sides horizontal. Maybe you have a junk laptop

See if this doesn't help you fix your PS2.
Repair your ps2 using this guide and and common household tools.
Free pdf download (28 pgs. 2006).
www.ps2homerepair.com

wrongaddress@att.net wrote:
 >I have an old 6 transistor radio (Spiket 2 Band, MW and LW) made in
 >Okenawa Japan. Complete with leather case, looks to be a late 1950s or

Unit is 3 years old, suddenly wont stay on longer than 3 sec o
so....standby switch blinks 8 times, Sony's online site codes say chec
IC406....I ordered online service manual, but it makes no reference t
an IC406 I searched the entire pdf doc...mmmm, so I did a littl

I need your help once again group. Zenith model #B27A30ZC5 TV. Found 2
burnt caps sitting by flyback. They are component numbers CX3212,
CX3210. I have searched for info on the net, but without a schematic, I
have no clue as to their voltage/value. Anyone have this info please?

What are the conventions?  Got one with a black stripe in the middle, red
stripe next on the end, then a red stripe on the leg.  It is on the input
(pin 4) to gnd of a STRG6624 in a Panasonic PS.  No schematics on this one.
This is the PT50LC14 that I was looking for the ...

About 3 weeks ago while watching tv, the picture went green with lines
running across the screens. I couldnt change the channel, there was no
volume and only thing I could do was switch it off. After about 20
minutes the picture came back on and it was fine.....

Do any of you know where to get electronic parts for a Ford cassette
player?
I've tried the dealer.  "Can't get any parts for radios."  Uh-huh...
It's just the ON-OFF/Volume control for the stock cassette player in a '97