| Thread | Last Post | Replies |
|
| DVD -Ram/DVD-R | 27 Apr 2006 01:30 GMT | 1 |
Panasonic M # DMR-E100H, While recording, came to end of disk...started writing, @ 61 %, locked up, then went into diagnostics...& stayed there. Can Windows XP Pro read this hard drive, to check it? If not, how do I
|
| voltage regulator C324C | 26 Apr 2006 23:04 GMT | 4 |
I have a power supply with what I assume to be a voltage regulator chip Its number is C324C Can anyone point me to a data sheet for this device? TIA
|
| Electronics Repair Help | 26 Apr 2006 21:27 GMT | 3 |
http://fletchersite.com/ask.html
|
| Easy money!!!!!!! | 26 Apr 2006 17:49 GMT | 1 |
Dear Internet User: Good Day! This article I've written is all about the fact where I earned an ASTOUNDING amount of money in less than a month and I've decided to share the secret with you...(yah you the one reading this
|
| Philips VCR948 | 26 Apr 2006 17:35 GMT | 7 |
This Philips VCR948 is still in mint condition and works as advertised when powered on. BUT...after 5 minutes it starts a life of its own. When commanded to the PLAY mode it starts spinning something but the tape is not pulled around the
|
| Peavey XR600 amp oscillation | 26 Apr 2006 16:58 GMT | 2 |
I am working on a PV xr 600 mixer amp that has two amplifier channels on the same board. I replaced smoked and shorted components and the amp does work but it clips early and oscillates on the negative swing of the wave form at about -20 volts driving an 8 ohm load. Funny
|
| MC1385P need data | 26 Apr 2006 10:26 GMT | 2 |
I'm trying to fix a drake UV-3 transceiver and I need a datasheet or at least the pinout of the MC1385P IC. There seems to be almost no information on the web about it (or I'm unable to dig out any).
|
| RCA ATC113CA1 shutsdown | 26 Apr 2006 06:40 GMT | 2 |
I got this TV I am working on, and the SMPS will fire, and the green power LED will come on, but the flyback makes a quick disgruntled ring, and shuts back down. Is there anything I should check before I replace the flyback, and what is
|
| WTB: 16 pin Socket Adapter for an ESI TTL Tester | 26 Apr 2006 03:46 GMT | 1 |
Looking to buy a socket adapter for a ESI TTL tester. The markings on the 14 pin socket are BARNES and the manual shows 16 pin socket p/n 20860 Anyone know where to get one?
|
| Nakamichi T-100 audio analyzer service manual | 26 Apr 2006 03:04 GMT | 1 |
I am looking for a service manual or schematics (or copies) for the Nakamichi T-100 Audio Analyzer that was sold in the late 70's. Any help would be very welcome.
|
| Inverter Repair... I could use some pointers from the experts. | 26 Apr 2006 01:39 GMT | 20 |
I have a NEC Multisync LCD 1525M Monitor with a bad inverter (built by Potrans model# DA00812600). It had a burnt 22 pF 3kv ceramic capacitor. It is the cap just before wher the ccfl lamp hooks up. I replaced this cap with the closest value I could find at the local surplus ...
|
| Emergency Warning Lights flasher, question? | 25 Apr 2006 13:41 GMT | 1 |
I own a 1999 chevy malibu, I am looking to put Item # FS044 http://galls.com/style.html?assort=general_catalog&style=FS044&cat=2707
>in my car. My question is can i simply swap this flasher for the Hazard light flasher, in my car so when i activate the hazard switch it will not ... |
| older electronics, computer mags | 25 Apr 2006 06:32 GMT | 1 |
I have several dozen electronic, computer, popular science, Amiga, you name it, magizines that I have digitized. Not only great reading but some great projects, repairs, again etc. If there is any interest in buying, or trades..... of this type of material.... let me know.
|
| Commodore 64 defect? | 25 Apr 2006 06:07 GMT | 17 |
An friend just contacted me about his old (But RETRO!!) Commodore 6 which emitted a lot of smoke when he turned it on. I got a picture o the mainboard, which in my opinon not much good, looks like moisture but i am not sure. Who can give an correct answer?
|
| Request for help: Locked-up Sony KV21X4D | 25 Apr 2006 05:21 GMT | 1 |
While fiddling around in Service Mode I managed to lock-up my Sony KV21X4D. It's similar to the KV21C4. I'm not very familiar with servicing TVs, so I'll try to describe the problem as detailed as possible. Hopefully somebody will be able to provide some advice on how
|