Electronics Forum / Repair / January 2005

I can't be the only one seeing this problem.
Have a JVC Model AV-27230 with what looks like a collapsing Vertical
Screen at the top, similar to what you'd see when a  Vertical Output IC
goes sour on most sets. In this case though it is Translucent, most of

Anyone that have this scheme to help me to repair a dificul problem.

Got a slight problem with it not wanting to spin at the end of a cycle.
Just popped out out of the blue. The Pump also seems to bail out all the
water it can, but since it wont spin its not much, clothes still wet.
It seems to agitate fine and do anything else. Its a direct drive, ...

As header no reserve its has to go fully working and with probes covers ETC
99p start (and still is) about £12 postage to the UK or pickup from Reading
UK
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&rd=1&item=3865087013&ssPageName=
STRK:MESE:IT

Hey Folks.
I got a Kenwood receiver that will operate two tape decks.  However, Tape "B"
is DIN cable only.  Is there such a cable that will go from DIN to four RCA
record/play male terminals?. I would like to use Tape B for a CD player/burner.

I recently bought the RCA RP3710A Alarm Clock radio. The problem with
it is that it randomly gains time. Never loses time. What I mean is
that it might run fine for 15 hours with the time right on to the
second and then boom, it gains a random amount of time. It might only

Make : Mitsubishi
Model : CK3536R
Part # 330P18101
The original one has a severe buzz (60hz).   Would like to have replacement

Does anyone know how to get the cover off??
I've undone the two screws at the bottom rear, but the top edge
doesn't want to move. I don't want to force it if there's an easy
way....

Just checking to see if anyone knows of a 'CPR technique' .
Player would sometimes play a CD from cold but never a second CD.
The cherry red laser output would drop off over time just by sight.
To confirm a laser problem not controller problem I powered

Got a Toshiba M # 24AF43, Chassis # M3M627.
Plug it in, barely visible out of horizontal sync video,
(basically, no video), no sound, change channels, &
you can see that the channel has changed! Looks like

My old Sony 27" Trinitron turned off while watching it and now it
won't turn back on. Unplugged the TV for several hours, tried again,
still does not work. Verified the AC outlet is working fine. Tried
turning on from both the front panel and the remote -- there is no

This Tv works some minutes and after came on standby mode alone , if we
start them again she works less time and came to standby again , each time
she works less time since she dont became to work without cold some time
It seems that are some component that became hot .. but I don't ...

Working on SD-V291 dvd/vcr combo. Will not read the dvd, but after a
few minutes saids incorrect disc. It will play CD's ok.
It came in with the dvd tray out of place and hitting the optic pickup
unit.All looks ok.

Does anyone know where a simple Joe can get the repair codes for a sony
kp-53hs10 projection t.v.?

Looking for some input on schematic design software.
I'll be reverse engineering some older digital circuits using 8086 processor
& support chips.
Budget is open depending on features.