Electronics Forum / Repair / November 2004

Hyundai HT15x11-100  For auction on e-bay. For IBM Netvista. Check it out..
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&rd=1&item=5139659439
or
http://tinyurl.com/65gfs

Anyone that has a circuit diagram for a Philips FA650 available?
Thanks, /Joha
--
Johan_A

TV BRAND: TOSHIBA
TV MODEL: 43H71
TV TYPE: 43'' REAR VIEW PROJECTION
  The problem occurred after I wiped the tv screen with a 3M

I'll pay $100 for a decent SERVICE manual or other documentation with enough
info so I can troubleshoot the power circuit.
Thanks!
If you have one, pls contact me at lexmark8792@yahooREMOVETHIS.com.

Mavica FD92 For parts for auction. The LCD and Floppy are good.
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&rd=1&item=3852166318
or
http://tinyurl.com/5cgu7

I may need to rent, for one weekend, things like a spectrum analyzer,
power meter up to 500W, and a clean signal generator. My question is,
what would be the good place to look for in yellow pages. I have not
found anything. This is what I need to test my ten Harris AM-7223 RF

I'm looking for a very small monitor that can display a *PAL* signal
from a video source (pal camera, vcr, etc.). The display should be at
most 1 inch, so portable tv are out of the question :-((((
i'm not good at electronics, so getting a small lcd and building a

I have a friends (honestly, it isn't me :) with a large screen
panasonic.
My main question is: How do I do the pincushion settings for all 3
colors? I only get one global set? I need to set the hsize for blue

I have a Black Decker bread machine B2005 2 lb. It developed a problem
that the motor cannot turn the dough even though without load it can
turn regularly. I.e. it doesn't have enough force to turn when there
is dough. Because the guarantee time is just over, I open it up. No

I need a bi-metallic switch, automatically resettable that closes
around 15F. A small inexpensive type, similar to the kind put inside
nicad battery packs to limit the dissipation of the batteries would be
ideal.

I have a dead Sansui TV/VCR combo that uses these in the power supply.
The second part is marked as above. Does that sound like a bonafide
part number for an opto that can be crossed to anything common? Does
anyone have any data on either of these parts? Thanks, Lenny Stein,

I just won 2 lots consisting of total of 10 Harris 7223 RF amplifiers,
at a liquidation auction. I would like to test them a bit.
They are rated 250 watt output.
I have a signal generator, a 25W power meter, and an oscilloscope.

I wonder if anyone can help me .
I have a FARNELL L30 .05 power supply
its quite old and unforntally I have a problem with it
R27 has burnt out and I don't know what value it was

Hey all;
I have a 17" Relisys 772 monitor that has a few intermittent problems. The
display will be fine for a while, then turn a pinkish colour (very hard on
the eyes!). At other times, the screen will just go blank (i.e. dark). Also,

My One-for-all Topline 5 universal remote control is suffering from dirty
contacts.  Easy to repair?  You bet!  I have a stumbling block though - I
can't get the thing open!
Can anybody offer any advice on how to open a One-for-all Topline 5 remote