Electronics Forum / Equipment / May 2008

I have found an old hp5326a that I would like to repair because I like to
restore old equipment.
Almost everything works apart input A. The problem seems to stay on the
input board p/n 05327-60034, because even swapping the two boards connected

I'm probably reaching in the dark for this but I'm trying to get hold of a
copy of the manual for this bridge.  If anyone can help I would sure
appreciate it.
   Thanks,

i need to measure a low frequency waveform from a DC circuit (voltage
up to 200mV). I need a sample rate of around 10Hz. to buy an
oscilloscope for this is a total overkill. I was thinking of using the
soundcard, but then realised it's AC coupled. any suggestions on a

We have been operating in Michigan for about 30 years and have
decided
to throw in the towel. Selling our entire inventory of Video,
Pinball,

Hi, anyone has the schematic diagram of old ('70s) HP 1710A Oscilloscope?
I'm need the horizontal deflection output and sweep generator sections only.
Otherwise the values of some transistors in these sections is also
appreciated.

In our office they've got this HP Laser Jet 3050 Printer/Copy/Scanner,
but without a manual. Since it's got a USB connector, I guess that's
for the scanner input to a computer.
I once used some HP software for OCR, so I'm guessing that HP

Does anyone have a manual or know the GPIB programming syntax for the
Integra Microwave TMF 1800H Programmable YIG Filter?    I bought one
used with no manual.
or if you know the GPIB syntax can you share it with me.   I have tried

While sorting some boxes of old junk I found a resealable plastic bag full
of tiny paper envelopes, a couple of which had Tektronix brand labels.
One envelope was marked: Tektronix 152-0177-00 Germanium tunnel diode, the
others were: 152-0434-00 and 152-0465-00

JC-Electronics
We can offer you:
Sale and exchange services for:
-    Simatic S5 and Simatic S7  (6ES5 / 6ES7)

    Amtronix Instruments, Inc will have HP8924C units with opt 060 (60 watt
input) at the Dayton Hamvention for $1600./ea  The Hamvention is May 16,
17 and 18th. We will be at outdoor space 3037. These units are
refurbished with a new CRT, the latest V8.04 firmware, calibrated with

I am looking for a pdf'ed service doc for the Tektronix 2710 Spectrum
analyzer,
Good someone give me a pointer where to download it...
tnx in advance

What is everyone's favorite 'scope probes?  We've gone through a
handfull of Oldacker & Cal Test probes, both keep getting intermittent
connections with the coax cable where it is crimped.  Anyone had
better luck with better brands?

I have a problem with a tektronix 2225 scope, the timebase isn't
working, all I have is a beam movement on the vertical axis, nothing
in the horizontal axis.
anyone can help me with this? or else anyone can send me the service