Electronics Forum / Equipment / April 2008

Hello, knows somebody where I can get the manual to service from the
oscilloscope  Lecroy 9350.
Thanks

    Amtronix Instruments, Inc. will again have refurbished HP8924C Service
Monitors with calibration and 90 day warranty's for $1600. at the up
coming Dayton Hamvention (May 16th-17th). These units have the 60 watt
input and make an excellent service monitor for general 2-way or ...

Does anyone know of a cheap mobile long distance (20+ miles) data
communication service that would work in a large city environment?
I'm looking into communication of prognostic data on vehicles.
Basically a bunch of vehicles would be traveling around within a

Anyone have a spare or unneeded set of 4 floppies with WSTR31 which is
the screen transfer software for a Tektronix THS720A?
Thanks

Connecting a sensor directly to a PC is the most cost-effective method
for high-precision power measurements, especially if a PC is already
used for data acquisition and evaluation. Moving the control and
measurement display away from the sensor and into the PC means you

Satori Technology Limited are able to make our product even smaller
with the use of a PDA. This gives the ability to have the measurements
you require to take "In your pocket".
For more information see:

WANT TO BUY: Lucent PSAX and STGR Stinger 23N41 Enhanced Router Module
300550613 23N29 DSP2D Voice Server Module 300433091
1com
http://networkinghardware.net

im currently troubleshooting a HP3455A for a annoying problem.
10V and smaller ranges all seem perfectly okay, as is ohms and AC
voltage, while 100 and 1000V DC dont.
Just after Power-Up the TEST mode gives me 7, 5 and 4 and readings in

I bought GPIB-USB controller from prologix recently.
I'm trying to download data from TDS540 a scope of Tektronix,but
writing
program only with programmer manual is too difficult.

I'm considering to purchase a pc based logic analyzer. After a bit of
shopping around I narrowed down my options to either the Logicport
from Intronix or the Annie-USB from Janatek, maybe even their Logic-16
as well.

I own an old Eveready #QCC4 battery recharger.  The indicator lights
work with all batteries except for 9v's.  On the lid, the directions say
to look at the manual for the case with 9v's.  I cannot find the
directions and the Eveready website does not offer any for my recharger.

Does anyone know either a cheap place to buy or a way to cheaply make
a 48 Pin TSOP Test Clip?  I really don't want to desolder and resolder
a 48 pin package.

I am performing testing on load cells over a thermal range (40-135F).
Currently I have a NON-insulated area made of Bent Sheet metal, this
area is relatively closed up with an opening on one side for the
application of hot/cold via a portable ceramic heater / air

Anyone have any info on a CTI LCS-1304 Synthesizer. Looking for
data on the DB-25 connector.
Thanks, Dick, W1KSZ