Electronics Forum / Equipment / June 2006

Greetings,  I am looking for pdf manual or schematic at least for the
Wavetek SAM 1 signal analysis meter. Vert out has just DC level in
spectrum mode.  Also any tips or handy applications of its use will be
apprciated.

I'm looking for an instruction sheet for installing the 1300 MHz
prescaler, Option 72XXA-331K, into the Fluke 7260A or 7261A counters.  It
is Fluke Stock Number 546087 (Instruction Sheet 72XXA-331K).  Fluke no
longer had any record of it when I checked.

To determine the required height to install microwave radio dishes, I need
to find the heights of obstacles along the signal path, including trees.  I
see that used surveying instruments go for over $500 on ebay, but I only
need vertical measurement.  I get the horizontal from GPS ...

Hello..
    Hopefully, someone can point to a source of connectors that
HP used on their test equipment during the 70's/80's.  On the front
of many of their pieces of test equipment there existed a small three

FA: 6 Chromalox 2002 Environmental Test Chamber Controllers
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&rd=1&item=7626323597
Text from the auction listing:

I want to record my my phone callsbut get poor results using a device on
the line socket.
So I want to use the handset lead.  There are four connectors in the
socket on the main phone.  

I'm trying to repair a Delta Sources MG-600 ultrasonic cleaner that blew its
output transistors. The original devices are unmarked, and I need schematics
or any information that would help me identify the device ratings needed to
replace them.

I just bought an older Fluke DMM 8060A together with an temperature
probe 80T-150.
As I do not have a manual for the probe (I found a manual for the DMM
on the Fluke website), I'm wondering how to set the probe for °C

I'm considering the purchase of a multi-function calibrator to handle up to
6.5 digit meters (or better).   GPIB support is probably essential.
An obvious candidate is the Fluke 5520A, possibly with the scope calibration
option though I can do without that as I have other ...

Any body know how to program this controller?  It has 8 buttons, 2 rows of 4,
on the front.  
thanks,
Greg Ferris