Electronics Forum / Equipment / November 2004

hi ;
i have 1971 , 1973 , 1974 & 1975 catalogs for sale .
$ 10 apiece .   you pay postage .        WALT

I'm after someone who can make an "Active Noise Cancellation Device".
If you're that someone and would like some extra cash please contact
me at jhill1000@yahoo.co.uk.
Thanks

---------
FA (1 day): Tek 2465A, SG504, SG502, PG508, PG501, 7S11 w/S-1
I have on ebay, for **1-day-only** auctions, the items listed in the title.
They are priced to sell quickly.

I am planning to buy a low end digital storage oscilloscope. My first
option was a TDS1002 from Tektronix but a sales engineer told me to
consider an IDS810 from ISO-Tech, as its price/performance is
-supposedly- excellent. I have never heard of that brand, so I have made

Wanted: 50mg Transistor 2-beam Scope must be good working condition
and Cosmetically clean and sound. from in the UK.
h.trunley@ntlworld.com

I found this unit at the local landfill and it has an output, however
the panel meter which doubles as a voltage or current indicator
depending upon which front panel switch you push in, does not indicate
anything. Does anyone have a schematic for this power supply or do you

I have a used, but perfect working condition, Dual channel BK Model 1570,
20MHz  O-scope for sale or trade. Unit works fine, selling w/o leads since I
need them for new Agilent scope. Photos upon request.$200 obo plus UPS
shipping

I have a lot of small stepper motors with 16 leads (8 pair of windings). Is
there some procedure I can go through to find the phase order of the
windings. I mean, I need to apply power to these windings, in order, so that
the motor will move in the most efficient manner. I tried an ...

I have a question regarding ten cells  of 1.2 V single cell nominal
voltage
NiMH and NiCd.
I have just NiMH batteries available. I know that the NiMH cells have

I have a 2465B that passes all calibration routines except parametric
measurements CAL 09 steps 2 and 3 which always indicate "LIMIT". All of the
rest of the CAL 09 steps pass. CAL routines 01, 02, 03 have been been
repeated a couple of times with no problems. The scope functions ...

Hello to everybody,
as a part of my thesis work I'm trying to design a device for driving
piezoelectric transducers, to be used as a portable non-destructive
testing device.

Looking for at least two terminal grabber connectors. I'll be using
them on
an HP 5005B Signature Analyser, to connect the "pod" to the board
under test, but they used to be found on a range of HP test equipment.

I wish use THS730A to measure two signal with about 160V ~ 200V
floating voltage. Does anyone knows that, will the THS730a be damaged,
if I don't use Tek's P5102 probes.
Please advise. Thanks!

Can anyone recommend a good bread board with a lot a features that I
can get to practice and test circuits?  Please e-mail me at
freakboy1979@mchsi.com with any info.  Thank You.

Where cani find equipment that makes my laptop work as a signal generator
which makes it possible  to simulate a crankshaft pickup signal  . The
pickup detects
tooths on flywheel for the starter motor.