Electronics Forum / Equipment / August 2004

I recently got an HP 16500A.  I have a 15510B logic analyzer card in
it and the 400 megasample oscilloscope card set.  The unit worked
fine, but the logic analyzer software didn't work because the software
was corrupted (CRC error message)

Dear Colleagues,
I just acquired an IFR 1500 Service Monitor (with options  01 and 02).
Though I have the operation manual I am seeking a book  showing
various applications for this incredible device.

I am looking for any info about this card I have.
All information I have about it is available on
my page http://matthieu.benoit.free.fr/133.htm
it contains two bipolar proms and an "inside" 26 pin connector

 Does anyone know the designation/PN for the Tektronix 7D13 Digital
Multimeter plugin?
 Also, the schematic and/or how to make working equivalent?

It's that time of the year again, when young men's thoughts turn to capital
budgets.
This year, I'm looking very seriously at getting a microwave sweep generator
to replace my aged HP-8350B. I need to cover 1 GHz through 18 GHz minimum.

I am trying to track down a Seiko MTP401-40 Thermal Printer module to
replace a Faulty printer from a Power Analyser.
I am located in Australia but none of the Importers can supply a one off of
this printer except for one mob who want $198 (Aud) for the Printer module.

I have recently acquired the better? parts of a Zeutschel CL2
microfiche reader, i.e. the heavy base-section with lenses
and slider mechanism.
What's missing is the 'hood' (with the matte screen and prob.

I have completed the OCR of the pdf Richard sent. It needs some work as it's
unedited from the OCR.
I've put it on my site and will update it when I or Richard have done a 1st
cut at the edit.

    I've ran into a situation where I need to sense a very large flow of
current (100A) at 24VDC or so.  This is for a motor supply feed.  The
problem that I'm running into is isolation because there is a
microcontroller that is part of the control circuit that electrically

HI
       my problem with a panasonic fax (kx-ft46) the fax not finished
the warming up process and the power turn off and then turn on
continousely.

I measure some behaviours of ferroresonant circuit and the main goal of
measurment is to
determine for which amplitude of AC voltage source i get current with
doubled frequency compared

I am trying to repair the probe on this HP Voltmeter.
The diodes in the diode bridge part of the circuit are blown. There is
no mention in the manual of what they are. They measure 0.3 volts in one
direction and high in the other. I assumed they were probably germaniuns.

Looking for service/operation manual for a Tektronix 492 spectrum
analyzer. It must be the manual for serial numbers B02999999 and
below...any advice?

i have a HP 1652B Logic-Analyzer. I am searching a printer for it. In
the Menue there are following printers selectable: Thinkjet, Quietjet,
Laserjet and Alternate.
I am searching a ink-printer.

I am looking for a source for a large circular silicon solar cell.   I need
one that is around 3 inches diameter or larger.  A 3 1/4 inch disk would be
the perfect size if I could find one.
In reallity, I don't particularly care if the disk I find is a single cell