Electronics Forum / Equipment / November 2003

We have an old HP 3852A Data Acquisition device we just purchased and
need it for an experiment.  We are kind of rookies at this stuff and
hoped that someone would have an old manual that we could have, borrow
to copy, or buy.  Thanks.

Does anyone know a site where I can find a TDS420 calibration program?
Thanks, Marco

I have a Fluke 8050A DMM with the optional NiCd battery pack.
Does anyone know of a modification I can make to it which will allow it to
operate (correctly and safely) with the batteries removed, so it runs from
the mains power only?

I looking for STK65020 = 5 pcs and datasheet. Please reply as soon as
possible, thank you.
Regards,
Ken

I am in the market for a cheap logic analyzer. I can't figure out the
main difference between an HP 1631D and 1651A. I think the 1631D has
the 50MHz scope, and the 1651A has the floppy for setups,but other
than that specs seem the same?? I want to play around with some DSP

The last time I turned on my Fluke 8600A about 6 months ago, it took a
couple hours to charge the battery. Now it shows only one digit on the
display. I checked the batteries and found 2 are 1.2 volts and 2 are
around .6

I am a student of Electrical & Electronics Engg. I have been given
"IGBT Tester" as my final year project at SIEMENS. I needed some
information on how to exactly an IGBT is tested. It would be of great
help if anyone could explain me the working of an "IGBT tester"

I have a Buchler PS, 1000/250VDC @ 25/250mA.
There is a meter for volts and amps.
When I turn the voltage knob I get a readout
on both ranges, however there is

I am designing a power electronic converter (converting a single phase
ac power supply to a three phase ac supply). I have purchased a three
phase induction motor (250 Watss,squirrel cage). In order to design my
converter i need to know the following components of the motor.

I want to buy a CRO (Cathode Ray Oscilloscope). How much will it cast?
And tips, which one to buy?
Regards,
Muthu

I've been using thermally conductive adhesive transfer tape 9882 a 3M
product. It is very expensive and only available by the case if anyone
wants to sell me a roll or split a case let me know. It's about $105
per roll and a case has 9 rolls. I really only need one roll! Thanks

I just got a TMC Directional Coupler Unit Model CU 2/50 and wonder if anyone
would have specs or a schematic?  Inside it has a  0.6 ohm 40 watt resistor
inline with input and ouput. Off each end of this resistor  there is a
silver

ALL,
Good morning, I am building a calibration set-point device for the
Hioki 3551.
To those who are familiar with batteries, the Hioki 3551 is a battery

Does any one know where in Seattle to get cheap discrete parts &
components besides Radio Shack?  I'm looking for stuff for projects like;
Resistors, Capacitors, Inductors, Transformers, Diodes, Transistors, IC's,
etc.

I need to be able to look at the bits/bytes going back and forth on a
serial line.  I don't really need to *emulate* anything in particular,
like *be* the DTE or DCE, I just want to sniff the line that two other
devices are talking on so I can troubleshoot.  Besides RS232, I need