Electronics Forum / Electronics / March 2007

"Jonno"  ?????
** An obvious fake name for an obvious bloody  FAKE  !!!!!!
This brainless, autistic  c.nt  can go post his
ASININE   sh.t  on some other newsgroup.

** Attention aus.electronics readers  !!!
Compact Fluoro Madness has overtaken the civilised world !!
---------------------------------------------------------------------
( Good thing there is still an uncivilised one left  - eh ? )

"Jonno" ??????????
** An obvious fake name for an obvious bloody  FAKE  !!!!!!
This brainless, autistic  c.nt  can go post his  ASININE   sh.t  on some
other newsgroup.

I'm an italian student and I'm searching a new meter for my hobby.
In this moment, I'm trying to repair a monitor, but I sometimes repair bike,
sometimes I work in the electric euipment of cars, etc.
So, I'm searching a meter (not too expensive... I'm a student!), and I'm

A dog chewed the lead plug off and I need the wiring diagram for it, anyone
help?

I need this old Elektor magazines in PDF:
Elektor(uk)_July75.pdf          16.12MB
Elektor(uk)Jan76.pdf          15.97MB
Elektor(uk)March76.pdf          17.97MB

** Hi to all my loyal fans....
a colleague raves about this stuff. -  has anyone here tried it ?
http://www.lanotec.com.au/
Uses the spray can version for all sorts of cleaning, particularly grimy

Electronics,  RADAR, is often said to be dead accurate.
But what if theyre not tested according to proper National Measurement
institute standards? The only legal method? You dont get booked? Of
course you do. The states are not using legitimate methods to test

Official letter soon to M. Jacques Ren Chirac, the President of the
French Republic, with copy to anybody who gives a sh.t.
Please bring back Madame la Guillotine and cut off Turcaud's tiny
pindick.

I'm looking for a good, relatively cheap, off the shelf analogue to digital
input device to use with the PC. Specifically I want to measure EM induced
currents from an antenna, so one input would be enough.
I have found these experiment board kits on a few US sites but they have

Hello to all.
I'd like to ask  your help about a card readr I recently found in my
garage...let me say that I'm not an expert in electronics: I'm able to
solder but I don't have a great experience in building circuits.

hi,  would anybody be able to supply me a link/schematic  to build a
optocoupler switcher for a  eprom ? (4n25  opto ???)
i want to be able to switch banks in a 27c128 etc eprom via long wires
connected to a mechanical switch.

Looking for some connectors in the UK, can anyone help please?
See www.roverp4.com/Connector
TIA
Barry

Official letter soon to M. Jacques Rene Chirac, the President of the
French Republic, with copy to anybody who gives a sh.t.
Please bring back Madame la Guillotine and cut off Turcaud's tiny
pindick.

I am familiar with using solid state relays to switch 110VAC using a low
DC voltage to activate.  Can these also be used to switch 12VDC (to pick
a 12 volt mechanical relay)?
                 ---MIKE---