Electronics Forum / Electronics / September 2006

I came across your yahoo group.
I would like to introduce to you a revolutionary product JetBrowse web
accelerator ( www.jetbrowse.com ) This software increases your
existing Internet connection speeds by more than 5 times. Please do

Would anyone know of a source of 40 way edge connectors as seen in the image
below?;
http://www.logicsays.com/pub/edge40.jpg
I've checked the various sites; RS, Farnell, Rapid, Maplin etc.  RS do them

If anyone is thinking of buying one of these, the silly table top antenna
gets 0 channels, plugging it into a boosted rooftop antennae gives full
signal strength indication but about half the channels still won't scan in.
The problem seems to be the receiver fails to recognise ...

if i have a phone with bluetooth 2, will it work with a bluetooth handsfree
device with bluetooth 1.1?

I had a good look at a speed detector on a police car the other day.
The unit said it operates on 24 Ghz.  (not 2.4Gig but 24Gig)
My knowledge of frequencies thus leads me to believe that the signal would
be extremely narrow, and even if one did make a speed camera detector, the

with the 18f chip, if i have to files AH,AL to represent one number and
BH,BL for another. (H and L are hi and lo obviously), how would i use the
instruction set to add and subtract a and b and taking care of the carry and
borrow bits. im thinking, with addition, you add the lo ...

I am after advice on a DC/DC converter to with specs as per the subject
title. I would prefer a pre-built solution similar to the readily
available 1 watt modules, however suggestions on suitable components
also appreciated. I have looked at the offerings from the usual

The kids are occasionally breaking their mp3 earphone wires due to
fatigue/catching and I repair them when I can. The modern ones have colour
coded enamelled wire and are both fine and flexible. I generally fix them
with some wire and heatshrink and try to rebuild starin reliefs ...

Hi can anybody point me in a direction to find  a simple tally light circuit
for a bit of filming i have to do. I would like to send the control signal
down the video cable.
Any thoughts

IN SHORT:
Other than the Canon MV-X430, what other camcorders can do
analogue/digital conversion on the fly (instead of capturing to tape
first)?  What is the cheapest?

Hi again,
  Sorry if this seems to be slightly off-topic. I'm looking for an
output paper feed roller drive gear for my Laserjet 1020. HP won't
supply it on its own.

Hello Embedded Electronics Experts,
For a real-time signal monitoring and logging application, I am loking
a small, low power and light weight microcontroller board. This board
will be carried on a remotely piloted model airplane. As the airplane

Electus distribution have the RD3480 light dependant resistor for around $1
in large quantities, but I would assume these should be around the 20 cent
or less mark.
I am after about a thousand of them. Any leads for suppliers?

I don't know if this is the wrong newsgroup. It is OK to correct me if not.
I want 4 to 6 pcs analog multiplexers to repair a old PCB.
The type is MP7501.
Manufacture: Micro Power Systems.

This weekend we experienced a power failure, and the bulb on my
conventional 2 D cell flashlight burned out. Fortunately I had a spare
PR-2 on hand.
For a replacement I went to my local hardware store, then Home Depot