Electronics Forum / Electronics / October 2004

Does anyone know where to buy a 28 pin DIP to single row IDC ribbon cable.
I have pictures if anyone can help.
Thank you
Jim Rojas

Simple (maybe) question. I've got a tin/lead plated circuit board, and some
components which have plated leads without lead. Is it possible to make a
good solder joint between these two? If so, what sort of solder should be
used (leaded, unleaded)?

model:CTM644
in good condition
Offers???
pls reply to email only

I'm doing work with some accelerometers on a vertical oscillator, and
want an easy way to gather the data.  They put out a voltage
proportional to the acceleration, and I'm looking for the peak to peak
voltage, to find the greatest acceleration. I can hook it up to a

Could anybody please email me a copy of the schematic and service mode info
if applicable for Orion ctv model 26ED.
I have tried Speedy Spares, but they do not stock.
Please let me know before sending.

I need to copy all my HD for other new HD. As to do that to maintain
all the information already existent, without needing to install all my
programs again.
Tks

Is there an online source for cable power amps
Brooks

I am looking for a low cost, low volume (100's) turn-key
manufacturer for a small electronic product, specifically
   www.nolindan.com/da/fstop/
I was under the impression there was some company in

           I am looking for a PIC chip that has quite a few outputs / data
lines, more than 32, do any exist?
Paul

I need help setting up this to an N factor of 1000.  I am trying to lay this
chip out on a PCB.  I have the manufacturer data sheets, but I don't
understand them.
Any help would be great.

I have two faulty PS 2's which need some work. Can anyone fix them for
me or know of a good person to fix them for me ?
Thanks
Sonny

Whilst removing an old factory fitted (Camry 91) tape deck, I accidentally
let one of the wires (+ charge) touch the metal bit causing the old deck to
fry. As the old system was connected to an amplifier (model Range TX-2000
which has NO info whatsoever on the web) ... well anyway ...

Hiya,
Hopefully this is the right place to ask.  But I have a problem with birds
and have been told that a ultrasonic sounder operating at the right
frequency should deter them and be inaudiable to humans.  I've been told

Has anyone used square wave modulation frequencies of up to 50kHz with these
modules or  sine wave audio frequencies ?. Thank you .... John

    Can anybody suggest me  good links for learning TV IR sensors.
        THANKS.
-SANDEEP
Posted Via Usenet.com Premium Usenet Newsgroup Services