Home | Contact Us | FAQ | Search & Site Map | Link to Us
Sign In | Join | Other 45 Sites in Network
Home
Discussion GroupsElectronicsBasicsRepairDesignCADComponentsEquipmentElectrical Engineering
ElectronicsKB.com
Contact UsLink To UsSearch & Site Map

Electronics Forum / Electronics / June 2004



Tip: Looking for answers? Try searching our database.

ThreadLast Post  Replies
patent drafting service17 Jun 2004 08:32 GMT3
Hello, my name is John.  I am a patent attorney licensed in two states
and before the USPTO.  Before starting my own practice, I was an
attorney at patent law firms in Chicago for 6 years.  I specialize in
electrical and mechanical subject matter.  My home is my office, so I
simple low power stero FM transmitter17 Jun 2004 06:32 GMT1
I would like to build one of these so i can plug it into my computer and
then tune a radio in the next room in to listen to stuff off my computer...
Dose any one know of any pre disended circuit available on the web to do
this??  IE ones i can just look and and build the PBC etc.. ...
please help me with a filter circuit with approximately 4Kz bandwidth.16 Jun 2004 21:52 GMT5
I am trying to develop an intercom that sends out audio signals of 4Kz
bandwidth (three different channels through the same cable/wire.
(Prior to making that, I am actually trying to simulate that on a
computer so as to reduce the cost).  I have double side band
TDA2030 inverting input16 Jun 2004 20:52 GMT8
On the TDA2030 (or any amplifier) Can I just simply swap the inverting and
non-inverting inputs invert (or non invert) A audio single ? Sounds a bit
too simple, though a guy I know isnt sure if its that simple or not, I will
try it tomorrow though assuming its not going to work how ...
flyback transofrmers uk ?16 Jun 2004 18:21 GMT2
I've tried a few common places for them, though £30 for one is a bit much
(and worth more than the monitor) Does anyone know of any reasonable places
in the UK which sells them or referbs ?
Thanks
Loose spring in Philips VR356 VCR. - tape wont load.16 Jun 2004 02:29 GMT5
Greetings group.
Philips VR356/75 vcr.
I found a loose spring about 1cm long.
The vcr loads the cassette, and the guide posts
newbie help16 Jun 2004 00:36 GMT1
   Im looking for some help regarding an electronic drinking game ive got
called shock roulette, where you put your fingers in a compartment and the
game countsdown and shocks someone at random, now the problem is its only a
mild shock (runs off 1 aa battery), now how can I up the ...
headphone out to line-in15 Jun 2004 23:22 GMT13
I have been asked to do a 400 trip in a cessna aircraft TOMORROW
and to film the trip using my sony camcorder
on previous occassions the built in microphones captures way too much
ambient noise and next to nothing of the intercom and tower
pet collar radio transmitter15 Jun 2004 22:56 GMT7
I purchased a radio transmitter controlled dog door not long ago.
http://hitecpet.com/autpetdoorfo.html
Problem is, I occasionally forget to take the collar off when I take the
dog to a park where he goes in the water.  I've now gone through three
eer15 Jun 2004 22:00 GMT11
Electronic electricity repository is an energy concept that aims to accumulate
and store electrical energy from any source.  The storage would be intended to
accommodate such things as electric vehicles, home heating, etc.  The best
example is the EV - an electric car that would run ...
phono vs line inputs on stereo15 Jun 2004 21:16 GMT8
My apologies if this isn't the proper sci.electronics group for this
question --
I have an old one-piece stereo, the kind that's designed to look like a
rack system but isn't.  It has just one set of RCA inputs, which are
Digital resistor/opto coupler15 Jun 2004 13:32 GMT5
I have a microcontroller board that has a variable analog voltage
output via a DAC.  I want to use this variable voltage to control a
potentiometer on another board.  Is there any device that allows me to
run the analog voltage output through two pins and get a variable
ditital voice15 Jun 2004 12:54 GMT3
Can anybody help me design a circuit that will digitize voice and
place the data into RAM, then read it and convert it back? The chips
from ISD won't work for my situation because there is no access to the
data. I want to be able to read the data in reverse to play the audio
faulty dvd/cd player15 Jun 2004 12:32 GMT14
I have a Technics SL-dv250 cd\dvd player which now fails to recognise the
inserted disc, you can hear it trying to read the disc, then you just get
the no disc message, any help would be appreciated.
http://reminisce.twbbs.org/nw/15 Jun 2004 05:17 GMT2
??
http://reminisce.twbbs.org/nw/
Pages: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 May, 2004
 
Sign In
Join
My Latest Posts
My Monitored Threads
My Blog
My Photo Gallery
My Profile
My Homepage

Start New Thread



©2009 Advenet LLC   Privacy Policy - Terms of Use
This website includes both content owned or controlled by Advenet as well as content owned or controlled by third parties.