Electronics Forum / Components / March 2005

20 years ago I bought a plastic project box with a grey non-transparent
"box" and a transparent screw-down "lid".  Size was about 6" x 4" x 3"
high.  The transparent lid was 6" x 4".  It was a really nice box, had
brass inserts for the the screws holding down the lid etc., guides ...

i need an application note describing a schematic for a linear position
sensor, in "time of flight" mode. The range of sensing is from 1 mt  to
1 cm, and the resolution less than 1 cm
thanks

I have the following items listed on Ebay at present:
- Wall or Trim Mount RJ45 Connection Boxes !            (50)
  http://cgi.ebay.com.au/ws/eBayISAPI.dll?ViewItem&rd=1&item=5762123827&ssPageName
=STRK:MESE:IT
And these Sun Microsystems parts are listed in Ebay as well:

Model # VV8220
Chassis # KM-201
TV stopped working (no picture, sound still worked)
I found a few burned resistors (value?), an open power resistor, and I can't

Looking for a source for small quantities (at least initially) of the
M51134P subharmonic synthesizer IC.  I don't know the manufacturer; I see it
listed on a couple of Chinese OEM web sites but no other information.
Google wasn't much help, and no listing at Digikey, Mouser, ...

where i can buy "that 4301" (that corporation)  in europe (or italy)?
ppm

I need a couple of 2sk2129s or equivalent, no minimums please.

Is there an equivalent chip for the display driver in a Fluke 8024b?
Chip is labelled
Intersil
429100

I need to burn some data onto a 27C020 EPROM but can't get my hands on one.
Can I use a 27C040 instead????

I everyones...I buy them on Ebay. When i can get some leds that match my
optical/electrical requirements, they're often in a clear package. I frost
them using high grit sand paper. Any quicker method you know? TIA for any
replies.

I'm looking for a complementary pair of BJTs with characteristics similar to
PN2222A / PN2907A, but with a bit higher power.  Audio frequency, hfe around
100 - 300, Vceo >= 20V; but they need to be able to dissipate 700mW
continuously (inside a small chassis), without damage.  ...

I'm looking for the manufacturer of the combo connector using in
the ATA hardrive.  Is this kind of connector off the shelf or
proprietary.  Appreciate for your help.
---------------------------------------------------------------

I've been gearing up to take on a new hobby project, building a wireless
MIDI controller.
I've done a fair bit of research and I am pretty straight on what parts I
need for the task and so on.

Estoy buscando informacion sobre el cxa2043Q
Gracia

Dear readers,
I work as distributor of electronic components. To recognize used ICs (also
called "Pulls" or "Refurbs") I need a microscope, which enables me to better
see scratches on the surface, bent leads, tin traces, etc.