Electronics Forum / CAD / July 2006

I want to have a good automatic placement with protel DXP .
is it possible?
and how?
Thanks and best regards,

Is there a generic diagram for car stereo dc power and ground?
thanks

All,
For a (hopefully) quick setup problem investigation I need to take a
look at some binary HPGL files to see what they are saying to my DGI
plotter to make it so angry. While there are thousands of viewers to

I am uisng Electronic work bench freeware 9, but when I print file, I
donot get good prints, i.e for eg. the pcb tracks are not sharp enough,
I am using adobe acrobat o print to PDF files.

We offer a full range of HF welders / RF welders and HF/RF Generators
and hydraulic presses.
_______   http://www.HF-WELDERS.com    _______________
Available HF/RF Welder Machines:

The bes
online
22 rapto
nicol

If someone licenses only the above and not the Schematic or Autorouter
modules are there any caveats or hidden surprises? Do you get the
libraries, CAM Processor and just about everything necessary to send
off relevant files to a PCB board house? Don't need the Autorouter and

I use Altium designer to auto-route my board, I set the Max Length -
High Speed Design Rule from Design>>Rules Menu. (Max Length = 38.1mm)
When the auto-routing is done, it seems that the Max Length rule i set
was not observed, i've tried to re-route many times but i got the same

Several weeks ago I asked for help with my old Protel Client 3.x
crashing under Windows XP and received a lot of help -- thanks. The most
promising solution was to run Protel under VM Workstation emulating Win
95, and that seemed to work for a couple days, then Protel began its

I'm looking for P-cad 2004 library for PCI bus edge connector.
SioL

Information and reviews on cellular phones,cellular phone plans,cellular phone accessories,cellular phone ringtones and much more.
www.allcellphone-site.com
---
MAF Anti-Spam ID: 20060707000315U0o0MrE8

I need to create a resistor whose resistance varies according to an
equation with the variables of the top and bottom voltage (ie. the
voltage across it). I use Altium (was Protel) but I suspect the
fundamental process is the same. My main concern is that it is what

  Say one lays out a one-sided board with the letter "G" in the lower
left corner.
  Then make four gerbers: X asis, Y asis; X mirrored, Y asis; X asis, Y
mirrored; and X mirrored, Y mirrored.

hi,i am having problems with using tsmc03 technology. i need to know if
this technology twin well or not? any example of this technology, any
documentation will welcome. thanks anyway.

I have a few licenses for Tango PCB+ v 2.21,  board layout software,
meaning real hardware keys. No fake "software to replace a failed key,"
copied manuals, or any BS like that. Real keys, legit licenses.
I also have one license/key for the RoutePro "auto router" which is