Electronics Forum / Basics / November 2007

that is can i substitute a single phase bridge rectifier BL08 in
place of a BL02 .....
where BL08 is   800v RRM / 560v RMS
and     BL02 is   200v RRM / 140v RMS

SEX  XEX  SEX  SEX  SEX  SEX
INDIAN  SEX  f.cking  STILL
ROMANCE  SEX  STILL
BATHROOM SEX  VIDEO  FULL MOVIE FREE

two questions:
*) where can one read proofs of circuit-theoretic theorems (Thevenin,
Superposition, etc)?
*)  can an fm receiver be substantially simplified (ie: simplified to

I'm trying to use a 555 timer to output a specific frequency for an
indefinite period of time, no more than a minute, for the application
I need it to output 2 signals at about 28 hertz (with some fine
tunning) independent of each other, I have a circuits I setup (that I

Hi experts,
At first, i though it may be a earphone  / device failure, but after
i
experience that issue with several devices, i decided to ask:

I've recently had a problem connecting trying to connect up a Nintendo
Wii console to my VGA monitor using a transcoder box and the Wii's
component output (which goes to the transcoder box) - I was finding
that the colours were very 'washed out' - turning down the brightness

Hi, I,m setting up a soundsystem in my room, and I wondering if there
was a way to set up some LED arrays to go with it.
here's the catch: I am limited to materials that can be gotten at any
radio repair place, as online purchases don't ship here. this means no

hi all, i am not ready to begin creating my own PCB, and i have a few
projects that i'd like to place in a more permanent home... perfboard
seems the best solution, and i already have quite a few... however,
the perboard that i do have are not laid out like a breadboard at all

How do I get Kicad's pcb editor to insert a via?
It's probably really simple, but I can't make it happen!
Argh!

This is mahak.
can anybody tell me what is virtual ground concept.I refer to Micro
electronics by Sedra & SMith.
There it says Virtual Groung is because of infinite gain of amplifier.

I require a multiple switch, with about three to eight terminals.
It should be inexpensive and compact.
Anyone please refer to availablity in NJ or NY region.
Thanks.

Hi, not sure if this is the right place to ask, but here goes.. I have
an old 1960's radio that uses two 6 volt incandescent lamps for the
dial.  Would it be possible to substitute these for NE-2 neon bulbs?
The side contact on the bulbs connect to the chassis of the radio

Or more appropriately, when is a uC not the answer?
I mean yeah, there's tons of super simple stuff in which a uC would be
overkill for today, but as prices come down and programming
environments get more 'accessible'.....

I have a bunch of grass 9A5 amps (EEG) and would like to modify some
of them for portable use in the field, do you know where I can get
rear connectors and the printouts specs, for power and input /
outpputs, thank you very much.

saga continues,
my repair project device uses a phillips MAB 8051 AH
microcontroller.
while trying to isolate trouble with a badly shaped clock signal